The piezoactuator-driven positioning table enables precision movement in two independent axes.

The adjusting range for both axes is 600 µm. An inductive position measuring system is integrated in the table for each axis.
The following components are used to control the table:

ase/nvs/c.300 - Low voltage control and
ase/mvs/a.300 - Measuring system box.

They allow for a linear-regulated and hysteresis-free movement in the x and y directions.

The LED's on the low voltage drive ase/nvs/c.300 indicate if the regulated area is exceeded e.g. due to mechanical overload of the positioning system.

L x B x H	(100 x 50 x 10) mm
Table mounting	tapped holes M3
Object mounting	pin Ø 3mm
Displacement	x-direction 400µm regulated (600µm non-regulated)
	y-direction 400µm regulated (600µm non-regulated)
Non-linearity	±3 %
Resolution	0.14 µm (1Bit)
Resonance frequency of the unstressed system	240 Hz
Positioning time at full stroke	regulated 100ms
Operating voltage	275V

	x-axis	y-axis	z-axis
Stiffness	0.120 N/µm	0.085 N/µm
Maximum permissible load	60 N	42 N	2 N
Regulated load depending on the position	10 N ... 60 N	8 N ... 42 N

The technical data was determined in conjunction with the control electronics ase/nvs/c.300 and the measuring system box ase/mvs/a.300.

Order Number	Release	Description
asy/xyn/g550/b.300	1.0	Positioning table
ase/mvs/a.300	1.0	Measuring system box
ase/nvs/c.300	1.0	Low voltage control unit

Contact

Actuator Standard Products

PDF Version

Deutsche Version

marco Systemanalyse und Entwicklung GmbH Hans-Böckler-Str. 2 . D-85221 Dachau Tel (+49) [0] 8131 5161 0 . Fax (+49) [0] 8131 5161 66

http://www.marco.de/E/D/asy/xyn/g550/002.html - Rev. 1.6 (2003-06-05) All Rights Reserved Any questions or comments about this page? webmaster@marco.de